PressToCheck™ JSP P3 Filters multi gas vapour and construction dust replacement filters.
Created with a hinge design to facilitate instant and accurate checking of the face fit, without effecting the seal of the mask to the face. Allow air to flow across the full area of the filter material, increasing efficiency and extending life. Large open area allows for lower breathing resistance and improved comfort. Features a built-in inhalation valve making the respirator easier to maintain. Low profile cover protects the enclosed pleated filter from moisture and foreign objects that could damage the pleats. Easily attaches to the Force 8 Respirator with a secure fit when applied.
- Press-to-Check Low Profile Cover
- Bayonet Fitting
- Reduced Breathing Resistance
- Conforms to EN 140 (Half-mask) & EN 143 (Filters)
- Durable thermoplastic rubber mask for superior fit to most face shapes
- Fully adjustable 4-point cradle suspension
- Low resistance exhalation valve for easy breathing, with stable mask configuration
- Compatible with range of PressToCheck™ filters
- PressToCheck™ filters allow you to check your face fit each time you don the mask
- Replacing filters is more cost effective than using disposable masks
How can you be sure that you have donned your mask correctly?
With the new patent pending Force8™ PressToCheck™ filters you can instantly check that you have the correct seal every time.
Comfort
FIT IT!
Don the Mask – Put the straps and harness over your head and pull the straps to a suitably tight and comfortable fit.
PRESS IT!
PressToCheck™ – Press the front and backs of both filter covers together to stop air from entering through the filters.
CHECK IT!
Inhale – No air should come through the mask. Adjust the mask and repeat until it doesn’t. Release when seal is made.
To see how to apply your PressToCheck™ JSP P3 Filters, click here.
